INSTALLATION PAIR Valve Removal kit Kawasaki KLX 250 300 R / SM

Products covered: PLE-125

Step 1 : Remove the fuel tank according to the owner’s manual. Locate The PAIR valve (1) and the cover (2).

Step 2 : Disconnect the PAIR valve (1) from the wiring harness and connect the electronic eliminator in its place.

Step 3 : Follow the pipe (3) that goes from the PAIR valve (1) to the cover (2) and the pipes that go to the air box (4) and (5) and unplug them. Seal the air box nipple with the provided rubber cap.

Step 4 : Remove the PAIR valve (1), the pipes (3)(4)(5) and their associated hardware from the motorcycle.

Step 5 : Remove the cover (2) and its bolts and keep the flange (6) to use in the next step.

Step 6 : Place the block off plate and the flange(6) over the reed plate (7), use the provided stainless steel bolts and washers to install the plate and tighten each bolt to 10Nm of torque, don’t forget to use thread locker.