INSTALLATION PAIR VALVE ELIMINATOR KIT SUZUKI M1800R C1800R

Products covered: PLE-303

Step 1 : Remove the fuel tank according to the owner’s manual. Locate The PAIR valves (4) and the covers (5).

Step 2 : Disconnect the PAIR valves (4) from the wiring harness and connect the electronic eliminators in their place.

Step 3 : Follow the pipes (2)(3) that go from the PAIR valves (4) to the covers (5) and the air box and unplug them.

Step 4 : Remove the PAIR valves (4), the pipes (2)(3) and their associated hardware (7)(8)(9) from the motorcycle. Keep the o-rings that seal the holes on the air box and install the air box block off plates using the PAIR valve bolts.

Step 5 : Remove the covers (5) and their bolts.

Step 6 : Place the block off plates over the valve reeds (1), align the holes in the back of the plates with the screws that poke out of the valve reeds, use the provided stainless steel bolts and washers to install the plates and tighten each bolt to 10Nm of torque, don’t forget to use thread locker.