INSTALLATION PAIR VALVE ELIMINATOR KIT KAWASAKI

Products covered: PLE-131, PLE-404, PLE-325

Parts:

1 x Pair valve eliminator

1 x Rubber cap

1 x Block off plate

2 x Stainless steel bolts

2 x Stainless steel washers

The idea of the whole procedure is to bypass the electronic PAIR valve of the motorcycle by replacing it with the provided electronic PAIR valve eliminator and plug the airbox hole of the PAIR system and the engine PAIR valve cover with the rubber caps included in the kit.

This kit will let you completely remove the PAIR system from your motorcycle.

Please read the steps carefully before starting the installation and note that the ignition must be turned OFF during the whole procedure

STEP 1: Lift and support the fuel tank. Locate the PAIR valve and the PAIR system hose connected on the PAIR valve and the airbox.

The PAIR valve can be found attached on the airbox

STEP 2: Unplug the PAIR hose from the PAIR valve. Unplug the PAIR hose from the airbox and keep the retainer piece.

STEP 3: Plug the airbox hole with the one rubber cap and secure it by using the retainer piece from the PAIR hose.

STEP 4: Disconnect the PAIR valve connector from the solenoid wiring harness and connect the provided PAIR valve eliminator to this connector.

STEP 5: Remove the screws that hold the PAIR valve attached on the motorcycle. Now it is free to be removed.

STEP 6: Remove the Airbox.

STEP 7: Locate the PAIR valve plate on the cylinder head.

STEP 8: Unscrew the two bolts of the plate and remove the external AIS plate.

STEP 9: Put the block off plate against the engine valve cover with the engraved logo facing outwards and align the block off plate holes with the engine valve cover holes. Use the provided stainless steel bolts and washers to install the plates and tighten each bolt to 10nm of torque

You have bypassed the PAIR system!

That’s it, now you can put everything in place and start the engine.

Thank you very much.

If you have any suggestions for improvement or if you wish to help, feel free to contact us through the contact form.