Menu
Your Cart

Our store will be closed from 17th December 2024 until 2nd January 2025 for Christmas holidays.

All orders and enquiries received during this timeframe will be processed from Friday 3rd January 2025.

INSTALLATION PAIR VALVE ELIMINATOR KIT CRF1000L AFRICA TWIN

Parts:


1 x Airbox rubber cap          




1 x Block Off Plate




2 x Stainless steel bolts and washers



The idea of the whole procedure is to remove the electronic PAIR valve solenoid of the motorcycle, to plug the airbox hole of the PAIR system with the provided rubber cap and install the provided block off plates to the engine valve covers.


This kit will let you completely remove the PAIR system from your motorcycle.


Please read the steps carefully before starting the installation and note that the ignition must be turned OFF during the whole procedure



STEP 1: Remove the fuel tank and Airbox.


STEP 2:Locate the PAIR valve and the PAIR system hoses connected on the cylinder heads and the airbox.

The PAIR valve can be found just above the cylinder heads on the inline engines or attached on the airbox on the V engines.

crf1000cbr500pairinst1.pngcrf1000cbr500pairinst2.png


STEP 3: Unplug the PAIR hoses from the PAIR plates on the cylinder head (1). Unplug the PAIR hose (2) from the airbox and keep the retainer piece (3).

crf1000cbr500pairinst3.png


STEP 4: Plug the airbox hole with the provided rubber cap and secure it by using the retainer piece from the PAIR hose.





STEP 5: Disconnect the electronic connector that is attached on the PAIR solenoid(4).


crf1000cbr500pairinst4.png




STEP 6: Remove the screws that hold the PAIR valve attached on the motorcycle. Now it is free to be removed.




STEP 7: Locate the PAIR valve plate on the cylinder heads



STEP 8: Unscrew the two bolts of each plate and remove the external PAIR plate (5).


crf1000cbr500pairinst5.png



STEP 9: Leave the internal flange plate inside the engine cover.


STEP 10: Put the block off plate against the engine valve cover and align the block off plate holes with the engine valve cover holes. Use the provided stainless steel bolts and washers to install the plates and tighten each bolt to 10nm of torque.


You have bypassed the PAIR system!


That’s it, now you can put everything in place and start the engine.


Thank you very much.



If you have any suggestions for improvement or if you wish to help, feel free to contact us through the contact form.