Menu
Your Cart

INSTALLATION SmartMoto Smart TRE

Products covered: STR-002, STR-001

The idea of the whole procedure is to have access to the connectors of the gear position sensor. Disconnect them and connect the Smart TRE between the connectors.


We have used a Suzuki SV 1000 and a Hayabusa 1st Gen as reference in some photos, however these instructions will be applied to all Suzuki motorcycles.


Please read the steps carefully before starting the installation and note that the ignition must be turned OFF during the whole procedure



STEP 1: Remove the front seat and lift and support the fuel tank.


STEP 2: Locate the Gear Position Sensor connection.

The Gear position sensor connection is a white  3 way connection with Black/Blue/Pink wires. You can find it to all suzuki models under the fuel tank on the left hand side




STEP 3: Unplug the connection by pushing the tab on the female side. (photo)





STEP 4: Connect each connector by aligning the tabs of the motorcycle connectors to the Smart TRE connectors (photos)




STEP 5: Put the fuel tank and front seat back in place



You have installed the SmartMoto Smart TRE!


Thank you very much.




If you have any suggestions for improvement or if you wish to help, feel free to contact us through the contact form.