INSTALLATION AIS Valve Removal kit Triumph Rocket 3

Products covered: PLE-135

Step 1 : Remove the fuel tank and the side airbox cover according to the owner’s manual. Locate The PAIR valve (1), the silencer (2) and the covers (3).

Step 2 : Disconnect the PAIR valve (1) from the wiring harness and connect the electronic eliminator in its place.

Step 3 : Follow the pipes that go from the PAIR valve (1) to the covers (3) the pipe that go to the silencer (2) and the pipe that goes to the air box and unplug them. Seal the air box pipe with the provided rubber cap and secure it with the hose clip (4).

Step 4 : Remove the PAIR valve (1), the silencer (2), the pipes and their associated hardware from the motorcycle.

Step 5 : Remove the covers (3) and their bolts.

Step 6 : Place the block off plates over the valve reeds, use the provided stainless steel bolts and washers to install the plates and tighten each bolt to 9Nm of torque, don’t forget to use thread locker.