INSTALLATION AIS Valve Removal kit Ducati 698 MONO

Products covered: PLE-214

Step 1 : Remove the fuel tank according to the owner’s manual. Locate The PAIR valve (6) and the cover (1).

Step 2 : Disconnect the PAIR valve (6) from the wiring harness and connect the electronic eliminator in its place.

Step 3 : Remove the PAIR valve (6) and the rubber pad (9). Plug the air box hole with the provided rubber cap.

Step 4 : Follow the pipe (7) that goes from the PAIR valve (6) to the cover (1) and unplug it.

Step 5 : Remove the PAIR valve (6), the pipe (7) and their associated hardware (8) from the motorcycle.

Step 6 : Remove the cover (1) and its bolts (2).

Step 7 : Place the block off plate over the valve reed (3), use the provided stainless steel bolts and washers to install the plate and tighten each bolt to 10Nm of torque, don’t forget to use thread locker.