INSTALLATION AIS ELIMINATOR KIT YAMAHA 700

Products covered: PLE-211

Step 1 : Remove the fuel tank according to the owner’s manual. Locate The PAIR valve (31) and the cover (22).

Step 2 : Disconnect the PAIR valve (31) from the wiring harness and connect the electronic eliminator in its place.

Step 3 : Follow the pipe (32) that goes from the PAIR valve (31) to the cover (22) and the pipe that goes to the air box (34) and unplug them. Seal the air box nipple with the provided rubber cap.

Step 4 : Remove the PAIR valve (31), the pipes (32)(34) and their associated hardware (33)(35)(36) from the motorcycle.

Step 5 : Remove the cover (22) and its bolts (23).

Step 6 : Place the block off plate over the valve reeds, use the provided stainless steel bolts and washers to install the plate and tighten each bolt to 10Nm of torque, don’t forget to use thread locker.