EVAP System Removal kit installation

Step 1 : Remove the side panels according to the owner’s manual. Locate The EVAP valve (13), the pipes (7)(9)(11) and the EVAP system canister (1).

Step 2 : Disconnect the EVAP valve (13) from the wiring harness. Remove the white plastic from the female connector with a small screw driver as shown in the pictures bellow.

Step 3 : Connect the EVAP Valve Eliminator in its place.

Step 4 : Follow the pipes (5)(8)(9) that go from the EVAP valve (13) to the cylinder and unplug it. Seal the nipple on the cylinder with the provided rubber cap.

Step 5: Remove the EVAP valve (13), the pipes and their associated hardware (5)(6)(7)(8)(9)(10)(11) and the canister (1) from the motorcycle.

Step 6: Reroute the pipe (7) from the fuel tank to the ground or to a catch can.